FORK COMPATIBILITY 2

EDC Tool, Fork Install Requirements

To install the EDC tool into your fork with the OneUp Stem, you need to remove your old star-nut and install the OneUp Stem with the EDC Stem Preload Kit. 
  • Remove your bar and stem
  • Use a star-nut puller to remove your old star nut
The EDC tool can only be fitted to your fork if all of the requirements below are met. 

Fork Requirements:
The EDC Tool is only compatible with 1.5" Tapered mountain bike forks. 
To install EDC in your fork you will need to check the 3 dimensions below (A, C, D)
A - Total Steerer Tube Length
Steerer tube length measured from bottom of crown to top of the steerer must be 183-230mm long (7.25-9.00"). Use a tape measure to check length.

C - Steerer tube Min Diameter
Minimum diameter 22.1 mm (0.87"). To check, you can push a 16g or 20g CO2 cannister or a standard mtb handlebar up through the hole in the bottom of your fork steerer. If you can touch your star nut, you're all good.  

D - Steerer tube Max Diameter (opening in the underside of your fork crown)
31.75 mm - 34.00 mm dia. (1.25-1.34"). This is to ensure the EDC fork plug can be fitted. This is not essential, but ensures the EDC tool cannot rattle inside your fork.

Forks that at NOT Compatible
- All Cannondale Lefty Forks
- Some Fox 32 forks - See "Steerer Tube Star Nut Diameter" above to confirm
- 2012-2015 Fox 34 29 Forks - See "Steerer tube Min Diameter" above to confirm
- All Giant Overdrive 2 Forks

Forks with non-standard setups
- 2016+ SRAM Pike Boost *
- 2016+ SRAM Lyrik Boost *
- All Ohlins RXF series Forks **

*Storage capsule will fit, but CO2 cartridges may not.
** EDC Fork plug will not fit