Things You Will Need
Assembly time, approximately 10 minutes. Difficulty: Easy.
SPECS
Compatibility:
22.2mm Bar Clamp - Universal 1x clamp. Including 12 speed XT M8100 , SLX M7100 and all 10 speed Shimano
SRAM Matchmaker X - SRAM MMX clamps
Shimano I-spec-EV - 12 speed XTR M9100, XT M8100 and SLX M7100
Shimano I-spec II - 11 speed XTR M9000, XT M8000, SLX M7000 only
Not compatible with 2x/3x systems (Front shifters), or remote lock out systems
Weight:
Remote with 22.2mm Bar Clamp - 46g
Remote with SRAM Matchmaker X - 43g
Remote with Shimano I-spec-EV - 43g
Remote with Shimano I-spec II - 41g
INSTALL INSTRUCTIONS
Loosely attach the hinged clamp to your handlebar (Left side of brake for SRAM, Right side of brake for Shimano)
Attach the remote body to the clamp using your preferred mounting hole.
Torque the remote body to the clamp using a 4mm hex to 3Nm
Loosen the 22.2mm clamp and rotate the OneUp dropper remote until the remote body is parallel to the brake lever
Snug the 22.2mm clamp to 1Nm max.
Remove the lever mounting bolt completely from the left brake using a 4mm hex
Depress the "Push to Open" button using a 2mm hex to fully open the brake lever clamp
Remove the plastic spacer from the inside of the lever clamp
Install the OneUp I-spec II adapter into the lever clamp
Loosely reinstall the brake lever clamp onto the handlebar
Attach the remote body to the I-spec II adapter using your preferred mounting hole.
Torque the remote body to the I-spec II adapter using a 4mm hex to 3Nm
Rotate the OneUp dropper remote until the remote body is parallel to the brake lever.
Torque the brake lever clamp to the manufacturer's recommendation
Remove the lever mounting bolt completely from the left brake using a 4mm hex
Depress the "Push to Open" button using a 2mm hex to fully open the brake lever clamp
Install the OneUp supplied T-nut into the curved recess on the hinged clamp
Reinstall the brake lever clamp onto the handlebar
Install the OneUp supplied IS-EV adapter onto the T-nut
Attach the remote body to the IS-EV adapter using your preferred mounting hole.
Torque the remote body to the IS-EV adapter using a 4mm hex to 3Nm
Rotate the OneUp dropper remote until the remote body is parallel to the brake lever.
Torque the IS-EV adapter bolt to the brake clamp using a 4mm hex to 3Nm.
Remove Brake lever mounting screw and hinged clamp using a T25 Torx
Install the OneUp supplied T-nut into the curved recess on the hinged clamp
Reinstall the brake lever clamp onto the handlebar
Install the OneUp supplied Matchmaker X adapter onto the T-nut
Attach the remote body to the Matchmaker X adapter using your preferred mounting hole.
Torque the remote body to the Matchmaker X adapter using a 4mm hex to 3Nm
Rotate the OneUp dropper remote until the remote body is parallel to the brake lever.
Torque the IS-EV adapter bolt to the brake clamp using a 4mm hex to 3Nm.